This will cause the incline motor to raise the running deck up. If the error is still shown, turn the treadmill OFF and unplug from the wall outlet. Yükleniyor... Çalışıyor... http://divxdelisi.com/treadmill-error/treadmill-error-code-e9.html The treadmill runs for a few seconds after pressing “Start” but stops, please check if the sensor (near flywheel of front roller) is loose or defective.
AC/DC-9 Power OFF and ON. Aerofit Treadmill Error Codes If the blinking heart symbol is displayed then the computer is sensoring your pulse properly. Check the circuit breaker reset switch located on the front of the treadmill.
Turn the power off, wait 5 minutes then press the rest switch.
If it has tripped, reset or have an electrician replace the breaker in home. This can happen when there is a bad wire harness connection or a damaged wire harness. The motor control board will shut down due to the motor pulling too much current, triggering a safety shut down. Treadmill Error Code E3 Then check if the LCD shows a blinking heart symbol.
If the error is still shown, turn the treadmill OFF and unplug from the wall outlet. AC/DC-4 Power OFF and ON. Ekle Bu videoyu daha sonra tekrar izlemek mi istiyorsunuz? this content Continue shopping View cart & checkout Continue shopping View cart & checkout Treadmill Repair Treadmill repair tips and spare parts supply.
Read article Treadmills Can Be Useful to Outdoor Runners Too! If it has tripped, reset or have an electrician replace the breaker in home. Turn the power off, wait 5 minutes then press the rest switch. Then lift the treadmill frame from the rear end slightly and check if the spring load knob can be locked in.
It could also just mean the incline motor needs to be adjusted back into range. The belt should move at 0.5 miles per hour. If the error code is still shown please contact customer service. Find the cable that goes between the board under the motor cover and the console.
Motor console damaged. No belt movement Motor is not receiving power: Call an authorized service technician Erratic display function Computer memory loss: Turn off and unplug the treadmill for 5 minutes and retry. + If the switch protrudes, it has tripped. Find the cable that goes between the board under the motor cover and the console.
Also note that not all models will have the ability to adjust the incline motor. Running Belt Noise New Running Belt: This is normal.
© Copyright 2017 divxdelisi.com. All rights reserved.